News:

 

Topic: keep edge/polygon selection after extrude/chamfer  (Read 6366 times)

0 Members and 1 Guest are viewing this topic.

  • Posts: 85
  • Edge
March 09, 2012, 11:53:02 pm
Hi Istonia,

is it possible to keep the edge selection after edge chamfer/extrude ?
I also noticed polygon selection is preserved when doing extrude/outset/inset but not when doing chamfer. I guess behavior should be consistent across all, similar, subcomponent operations.
Thanks!

  • Posts: 547
  • Administrator
  • Polygon
March 10, 2012, 01:27:59 am
+1 to this, good to keep everything realy consistent between other modes, and in the case of edges that is just very usefull too,

  • Posts: 547
  • Administrator
  • Polygon