NVil Forum
General Category => Feature Requests => Compleated => Topic started by: Memag on March 09, 2012, 11:53:02 pm
-
Hi Istonia,
is it possible to keep the edge selection after edge chamfer/extrude ?
I also noticed polygon selection is preserved when doing extrude/outset/inset but not when doing chamfer. I guess behavior should be consistent across all, similar, subcomponent operations.
Thanks!
-
+1 to this, good to keep everything realy consistent between other modes, and in the case of edges that is just very usefull too,
-
http://voidworld.cmcproductions.co.uk/index.php/topic,176.0.html