News:

 

Topic: spaceloop, curve loop, circularize broken with Symmetry on  (Read 6497 times)

0 Members and 1 Guest are viewing this topic.

  • No avatar
  • Posts: 162
  • Spline
    • Portfolio
February 21, 2012, 04:39:39 pm
Hi Istonia,  bug here that seemed to have been fixed for a while is back, not sure when but I've missed a few iterations of Voidworld.

As the title suggests. If I have symmetry on and I make a closed edge loop selection and try to run the Circularize command the loop will become circular but the spacing is messed up.. and further repeated presses of Cicularize will mess it up even further.

*edit 1*
I should note that this only happens when the edgeloop is connected and runs through the axis of symmetry.
« Last Edit: February 21, 2012, 04:56:26 pm by ghib »
Senior 3D Artist

  • No avatar
  • Posts: 3705
  • Developer
  • Administrator
  • Polygon
February 25, 2012, 11:06:13 pm
ghib, can you test it with the new version and see if it's ok now?

  • No avatar
  • Posts: 162
  • Spline
    • Portfolio
February 27, 2012, 01:41:10 pm
Works brilliantly so far.  I just tried it on a default cylinder that I messed up with soft selection.  I'll try it on some more complex geometry in the future and give feedback if there are any issues.

Cheers
Senior 3D Artist