extrude loops snap to spline

When opening up the extrude options there's an option "snap to spline". But only the end of the extrusion snaps to the spline, the inbetween loops follow a straight line. I would find it convenient if these loops would also snap to the spline at their respective positions. I know this behavior from Maya and I think Silo.
When extruding "by hand", I mean step by step along the spline it gets quite inaccurate to place the loops at the same spacing, or afterwards I would have to use space loops/tidy loops. But this whole process takes a lot of time and doesn't deliver the wanted results.
I tried to fiddle around with the slide command for splines, but the process to get a mesh out of it and attach it to your existing one (extract spline, slide, flip normals, merge etc.) is too complex.
So basically what I want to suggest is to include the splines slide options into the face extrude function.
Thanks for paying attention!

Hello,

Use the MMB(middle mouse button) to select the spline. That will extrude along(following) the spline and the "Extrude along spline" options (popup) will show.

Whooo! Thanks a lot! That's exactly what I was looking for. There's a lot functionality in this software, but I find it difficult to find out about it and how it works. There are a lot of similar tools that are slightly different, especially when it comes to streamlinetools. And I often find me wondering, what the difference is. Could be definately slimmed down to be more consistent.

I have only been using Nvil for a couple of months, so am still finding tools I have not tried yet.

Although I agree that some slimming down could be made, I would be concerned as to what tools are removed/merged, as some users may already be set up and happy with tools that may get removed. So I do prefer the tools remain and then a personal choice can be made.