News:

 

Topic: Snap Magnets For Slide  (Read 5638 times)

0 Members and 1 Guest are viewing this topic.

  • Posts: 496
  • Triangle
May 24, 2013, 01:55:44 pm
In Maya there is this feature called Snap Magnets. In the preferences, you can set up how many evenly spaced snap magnets should occur on a single edge. I'd like to also have this in NVil for the slide and cut&slide tools. It should take the snapping tolerance into account, and maybe only apply if steppings are enabled, so one can temporarily activate/deactivate it.
This is similar to the proportional loop insert with "use input position" enabled, but it works more like snapping and in steps instead of a fixed value.
For the slide without cut the magnets should be on either side of the selected components, while also keeping the original position as a magnet.

  • Posts: 89
  • Edge
May 29, 2013, 07:32:44 am
This sounds really nice, certainly if the snap-points could be visualised on the edge!

  • Posts: 496
  • Triangle
April 01, 2014, 01:24:45 am
So I think NVil isn't up to par with its cut & slide abilites, because it lacks stepping or snapping.
Stepping is already available in some tools, like inset.

For loopcut there's the proportional option with input, but it isn't quite enough, because it's less flexible. So instead of inserting the loop at the fixed .25 position, for example, it should insert it at every nth .25 position (so there would be 3 possible positions for that value, not counting 0 & 1).

As videos can show off more than I can explain with words, here they are:

Blender - Loop cut and Slide w/ stepping
http://youtu.be/1Aggft6JP2s

Maya - Cut w/ snapping
http://youtu.be/GsSTVwAd1Sg

Maya - Edge Slide w/ snapping
http://youtu.be/5m-GgYpA_iM