0 Members and 1 Guest are viewing this topic.
But tris and quads as shown in the shot is possible. The shot is from trueSpace. I`ve filled the Ngon with quads and tris with the quadrify tool there.
Hm, cannot get this one to work. I haven`t found the makequad command in any menu yet. But i`ve hotkeyed it. Unfortunately i cannot hold down my hotkey, click with the mouse, and also reach the plus button. I would need a third hand.What i did was to activate the makequad tool in the Smart tips with selected Ngon. When i click at the Ngon it turns into the quad geometry. But even here it doesn`t help to press + or - to change the mode. It always creates the same geometry, adding vertices at the cutting points.
The +/- keys are not the ones on the num_pad, but along the top.
I don't think the result of quadrify in the pic is close to what you actually want. It is just a mess.
I would not describe it as a mess, but would not (since naming appears to be so important at times) call the tool that created it a "Quadify" tool, given the results are not all quads.