What are you Working on?

thanks rubberDuck

2 work days, softimage + nvil

week 31 of the polycount HP challenge

Superb work! Would mind sharing some wires of this canister?

not a very pretty sight mostly because It was a rushed out model

Thanks. Much appreciated. It's always nice to see some wires.

American Pershing Tank

Another view....will take this into 3d coat and sculpt a bit of damage.

Dandy! Did you make tracks in Nvil?

I tried to get the tracks instanced properly along the spline, but they would not orient to the spline, so I did this in Maya.

Hi Mason

I made this tank in NVil and created the tracks as instances along a spline path also in NVil.  The secret is the initial orientation of the master tread and spline.  I posted a query in the Community Help section under a thread called "Positioning tank treads along a spline" and followed the advice in this thread and manged to achieve the result you can see.

Hope this helps.

Cheers
Mal

Awesome tank! Can you share a link to the thread? Thanks!