News:

 

Topic: Vertex mode toggle  (Read 1885 times)

0 Members and 1 Guest are viewing this topic.

  • Posts: 514
  • Polygon
June 21, 2020, 03:22:15 am
Selection > Selection Modes > Vertex Mode  (Jun 14 - I have 1 mapped to this command)

I find this behaviour strange in Nvil and there might be a reason for it.

When I hit the 1, I go into vertex mode as intended. If I hit the 1 key again it toggles into edge mode.

This behaviour also happens with edge, polygon, mesh and object modes when the mapped key is hit a second time.

The reason I find this annoying is that often I do some editing in vertex mode, before I start my next round of edits I automatically hit the one key to begin but find myself in edge mode. I have multi selection turned off.

  • No avatar
  • Posts: 176
  • Spline
    • White-creatures
June 21, 2020, 08:29:57 am
Hi keyjon,
could it be that you have the option "Allow subobject type hotkey toggle between previous type" turned on?
It's in the Preference > Options 2 > Modeling section

My side here doesn't have this problem, when I switch to vertex mode, repeating the same key doesn't switch me to another mode.

  • Posts: 514
  • Polygon
June 21, 2020, 09:30:16 am
Thanks Miica for pointing me to the problem.

It was turned on. I've now turned it off and now working correctly,  :)

One of those settings that can cause frustrations if set incorrectly.

  • No avatar
  • Posts: 3705
  • Developer
  • Administrator
  • Polygon
June 21, 2020, 10:20:48 am
It is a requested feature.