Home
Help
Search
Login
Register
Welcome,
Guest
. Please
login
or
register
.
Did you miss your
activation email
?
News:
NVil Forum
»
General Category
»
Community Help
»
Inset
« previous
next »
Print
Pages: [
1
]
Author
Topic: Inset (Read 7196 times)
0 Members and 1 Guest are viewing this topic.
Posts: 2101
Polygon
steve
July 23, 2012, 10:50:14 pm
Hello,
I will post here as I may possibly be missing an option.
When creating an inset, I have always believed(and usually see) that the new edges created are based on the perimeter edge bisectors, rather then being controlled by the edges within the selection.
Let me give an example.
2 polygons, one (left) as single, and one (right) with 2 cuts that intersect 2 corners.
Using "Inset", (on the single uncut polygon) new edges are created calculated from the perimeter bisector angles at the corners. But the polygon with the cuts, rather than new edges being created, at the vertex where the internal edge(s) meet, a new vertex is created and slides down that internal edge which gives a poor result.
What I would normally expect, is for new edges to be created from perimeter on both, giving a result as:-
Regards,
-Steve
Logged
Posts: 3705
Developer
Administrator
Polygon
IStonia
July 26, 2012, 11:28:26 am
The option you want is added.
Logged
Posts: 2101
Polygon
steve
July 26, 2012, 06:29:48 pm
Thank you very much.
Best Regards,
-Steve
Logged
Print
Pages: [
1
]
« previous
next »
NVil Forum
»
General Category
»
Community Help
»
Inset