shortcuts question.

Why when I assign shortcut to a tool it hold previous shortcuts that was assigned to it key? How it can be that obe key hold diffrent shortcuts?

it is up to you to decide if the hotkeys are conflicting or beneficial.

it dost remove conflicts since sometimes conflicts are what people want, since there are lots of tools that only work in 1 context, and not others.

And sometimes you want conflicts in the same context as well.

good example is my a, s, d, f keys all got conflicts on them, they are bound to switching between different component modes if tapped, but if there are held they enable snapping for that component mode.

... but if there are held they enable snapping for that component mode.

Doh! Why didn't I think of doing that? - thanks for the tip, mate!

... but if there are held they enable snapping for that component mode.

Doh! Why didn't I think of doing that? - thanks for the tip, mate!

ya works great since when snapping for the most part im either in the translate or pivot placement tools so not really needing hold any other keys, so i can bind my temporary snapping commands to the same keys as my component keys, and just hold the key for the current component mode if i want to snap to said component.