Retopo

Due to a post on forum I was looking at "Retopo"

With reference to "Spline > Sides"
In the help file it states:-
{Modeling > edge selection > Retopo:- "By selecting splines > To connect splines to form a mesh: 6"}

Press down Ctrl key, then scroll WMB to change the segment number. Release Ctrl Key

When performing that function, the WMB actually changes the number of "Sides" (the "sides" in this case, being the number of edges connecting the splines)
That help file section then goes on to state:-

Set the Sides value and click the apply button or hit enter button on keyboard

That actually does nothing, and the sides have already been set with the WMB in last part.

So something is incorrect, the help file or current implementation.

Please check when you have time.