Use tool in other mode

Hi guys, how to make that tool to vertex operated in the polygon

That is, being in the same mode I could use the tools drugova, i did not need to switch back
For example, could use vertex weld in poly mode
________
Привет парни, как сделать чтобы чтобы инструмент для vertex работал в режиме polygon

То есть находясь в одном режиме я мог использовать инструменты другова. при этом мне не нужно было переключатся назад.

Did you try using multi-selection? Edit >> Options >> Multi Selection or you can find it in the category Modeling Options. I would say that does the job good enough.

It's not something in the multi-selection is not very convenient to work

You would have to setup different composite tools mapped to a streamline tool to do this.


It is certainly possible though.  The composite tool would put you in the required component mode to use the tool you want.  Then map different composite tools to a streamline tool so that you can be in any subobject mode.

Thank you, I experiment with them.

Vauquero's suggestion also works though.