Divisions, recall and keys

Hi,

I'd like to be able to set divisions (loops, iterations) for Bridge tool with hitting numbers 1-2-3-4 etc (or even using a mouse wheel?), just like Extrude and Inset tool.
Also I found that Chamfer recalls previous divisions on the next usage while extrude and inset don't. Also Chamfer recalls the same division number for both poly and edge mode, which could be separated if we are going to recall the divisions. I would prefer for them not to be recalled, at least not when using streamline tool..
I couldn't set to no divisions while using Chamfer tool.

So I think it would be good if all the tools had the same functions.

thanks

+1 the divisions should only be recalled if you just tap the bevel button to redo the last bevel. should be reset to 1 if your doing a new bevel.