NVil Forum

General Category => Bug Reports => Topic started by: TinyTracker on June 17, 2022, 05:31:52 pm

Title: Cylinder tool and MMB
Post by: TinyTracker on June 17, 2022, 05:31:52 pm

Click cylinder.
Draw 1 stroke with cylinder tool activated.
Now while drawing the second stroke for the depth of cylinder. Click middle mouse button to toggle the radio buttons for X, Y, Z. The cylinder will change direction.
Move the mouse around while adjusting the depth and the cylinder orientation will reset.

Title: Re: Cylinder tool and MMB
Post by: rubberDuck on July 04, 2022, 09:24:04 pm

I could not reproduce the problem you're describing. When I move my mouse to set depth after changing orientation, the orientation does not reset. It only changes direction to a negative of a selected orientation if I move past the origin of the orientation axis.

The only problem I noticed is that setting depth is a little choppy, but it might be because I'm running NVil on GNU/Linux.

Tested on NVil 2022-Jun-26, so perhaps it was already fixed(?).

Title: Re: Cylinder tool and MMB
Post by: steve on July 13, 2022, 12:00:59 pm

Quote from: rubberDuck on July 04, 2022, 09:24:04 pm

Tested on NVil 2022-Jun-26

Where did you get that build from. I do not see a link on the forum.

Title: Re: Cylinder tool and MMB
Post by: rubberDuck on July 14, 2022, 09:38:56 pm

It might be one of test versions IStonia sent me after a bug report or feature request.