NVil Forum
General Category => Bug Reports => Topic started by: kevjon on June 21, 2020, 03:22:15 am
-
Selection > Selection Modes > Vertex Mode (Jun 14 - I have 1 mapped to this command)
I find this behaviour strange in Nvil and there might be a reason for it.
When I hit the 1, I go into vertex mode as intended. If I hit the 1 key again it toggles into edge mode.
This behaviour also happens with edge, polygon, mesh and object modes when the mapped key is hit a second time.
The reason I find this annoying is that often I do some editing in vertex mode, before I start my next round of edits I automatically hit the one key to begin but find myself in edge mode. I have multi selection turned off.
-
Hi keyjon,
could it be that you have the option "Allow subobject type hotkey toggle between previous type" turned on?
It's in the Preference > Options 2 > Modeling section
My side here doesn't have this problem, when I switch to vertex mode, repeating the same key doesn't switch me to another mode.
-
Thanks Miica for pointing me to the problem.
It was turned on. I've now turned it off and now working correctly, :)
One of those settings that can cause frustrations if set incorrectly.
-
It is a requested feature.