NVil Forum
General Category => General Discussion => Topic started by: apocalips on January 22, 2012, 11:19:39 pm
-
poly face is inside the 3D model how reverse face polygons ?(http://img36.imageshack.us/img36/420/leadwerkstest3d.jpg) ( in other 3D programs, and Leadwerks engine ) ::)
-
To display back facing polygons, Rendering > Back Face In Gray.
For partial work, under polygon mode, select those back facing polygons, then Geometry > Flip.
To flip the whole mesh, under Mesh mode, select the mesh then Geometry > Flip.
-
works thanks ,but in the next versions, I think that would be better to be the outside polygons (standard as the rest of 3d programs)
-
it is default to polygons facing outward. it must of got messed up somewhere along the modeling process, or if you started with a plane and had the wrong side faceing out.
-
you're right, sorry ;D