NVil Forum

General Category => Bug Reports => Topic started by: steve on December 28, 2012, 04:09:10 pm

Title: Chamfer segments/offset ?? (Fixed)
Post by: steve on December 28, 2012, 04:09:10 pm

Hi IStonia,

There is no mention of a change to the chamfer tool in update Dec/28/12, however, it appears a change as been made.

Simple example:-

When creating a 2 segment rounded chamfer on a cylinder, from a side view you can see (in previous versions) the segments are created so that all new segments divide up the angle.

(http://i.imgur.com/Od591.jpg)

In the latest update, when using the same 2 segments, it now appears the outside segments are actually being created as if they where offsets.

(http://i.imgur.com/2F4MZ.jpg)

When you have time, could you please check this?

Thanks,

Title: Re: Chamfer segments/offset ??
Post by: IStonia on December 29, 2012, 12:36:46 am

Fixed

Title: Re: Chamfer segments/offset ??
Post by: steve on December 29, 2012, 05:49:16 am

Hi IStonia,

Although it is fixed for the simple cylinder example, the chamfer rounded is still broken from previous versions.

Another simple example.

A box with 2 opposite sides removed and a rounded chamfer added to one edge, again it creates the 2 outside segments as offsets.

(http://i.imgur.com/9bvhG.png)

When you have time, could you please re-check?

Thanks,

Title: Re: Chamfer segments/offset ??
Post by: IStonia on December 29, 2012, 07:48:29 am

Fixed.

Title: Re: Chamfer segments/offset ??
Post by: steve on December 29, 2012, 06:50:20 pm

Hi IStonia,

If you check with the first simple example, the cylinder, you will find the chamfer rounded is still broken, but with new bug.

Single chamfer rounded added to end of cylinder:-

(http://i.imgur.com/x7CWh.png)

--------------------------

Fixed in update 31/Dec/12

Thank you.

Title: Re: Chamfer segments/offset ??
Post by: IStonia on December 29, 2012, 09:02:55 pm

Should be ok now.