NVil Forum

General Category => Bug Reports => Topic started by: steve on November 05, 2012, 10:36:09 am

Title: Extrude > Spline > Auto spline offset (not a bug)
Post by: steve on November 05, 2012, 10:36:09 am

The offset made by the "Auto spline offset" on the "Extrude > Spline" is flipping path side.

Simple example pic:-

Title: Re: Extrude > Spline > Auto spline offset
Post by: IStonia on November 05, 2012, 11:00:31 am

Can you send me the file?

Title: Re: Extrude > Spline > Auto spline offset
Post by: steve on November 05, 2012, 11:16:12 am

Simple example file sent.

Title: Re: Extrude > Spline > Auto spline offset
Post by: IStonia on November 06, 2012, 03:10:47 am

I think it is fine. When this option is used, the program will move the spline to place its starting point at the selection center before the operation. After the operation, the spline's position is restored.

Title: Re: Extrude > Spline > Auto spline offset
Post by: steve on November 06, 2012, 08:59:48 am

So it is not an "Auto spline offset" it is an "Auto spline align" [to selection bounded box center position].