NVil Forum

General Category => Bug Reports => Topic started by: steve on October 20, 2012, 04:32:43 am

Title: Slide > Scale Modify (Fixed)
Post by: steve on October 20, 2012, 04:32:43 am

Hi IStonia,

Not completely sure if this is a bug, but the result is not what I was expecting.

Simple example:-

Using "Slide" on a semi-circle(open spline) then adding a "Scale Modify", the scaling is not around Path as I expect, it is forcing the resulting mesh to be partially created below center line of path.

(http://i.imgur.com/Bw29N.jpg)

If instead, I simply "slide" the semi-circle, then on the resulting mesh, perform a "Spline modify" with "Scale Modify" I get the result I was expecting when using scale on the Slide.

(http://i.imgur.com/502MI.jpg)

Thanks,

Title: Re: Slide > Scale Modify
Post by: IStonia on October 20, 2012, 04:40:25 am

Can you send me both files?

Edit: Don't bother to do that. I've found the problem.

Title: Re: Slide > Scale Modify
Post by: steve on October 20, 2012, 06:42:47 am

I had already sent them.

Thanks for finding the problem.

Title: Re: Slide > Scale Modify
Post by: IStonia on October 21, 2012, 10:09:10 am

Fixed. The profile spline's geometry center was used as transform center. I have changed it to the profile spline's object pivot point, something you can control.

Title: Re: Slide > Scale Modify
Post by: steve on October 21, 2012, 07:37:00 pm

Many thanks,

Regards,

-Steve