NVil Forum
General Category => Bug Reports => Topic started by: steve on October 11, 2012, 11:30:52 am
-
Hello,
Not sure which is the bug(s)
When extruding edges, and the [selected]snapping is active, extrudes made by the "Cursor control"(manipulator direction) / "normal direction" and "face direction" do not always maintain correct direction, as they can snap away from correct direction to active snap points.
When extruding polygons, any active snapping is ignored/not used apart from when extruding "in individual directions", but the extrude direction is OK, the snapping is made by projection.
Thanks,
-
Fixed.