NVil Forum

General Category => Feature Requests => Topic started by: mogul on May 17, 2016, 04:33:44 am

Title: streamline edge(spline) to tube
Post by: mogul on May 17, 2016, 04:33:44 am

if i want to my edge loop to be tube i must be goto create spline open/close and select the spline and do command slide

can you make if select the edge/edge loop/spline it will make automatic tube
using mouse drag,ctrl and shift?
(http://s32.postimg.org/oaj9z887l/streamline_slide.jpg) (http://postimg.org/image/oaj9z887l/)

i have some problem istonia. when i do create spline open/close from the edge loop of my geo at the image below it will be make a spline at left. The spline not created per edge loop like on the right. I think the right is correct

(http://s32.postimg.org/cxljq8ccx/edge_to_spline.jpg) (http://postimg.org/image/cxljq8ccx/)

Title: Re: streamline edge(spline) to tube
Post by: IStonia on May 19, 2016, 06:46:46 am

Quote from: mogul on May 17, 2016, 04:33:44 am

i have some problem istonia. when i do create spline open/close from the edge loop of my geo at the image below it will be make a spline at left. The spline not created per edge loop like on the right. I think the right is correct

(http://s32.postimg.org/cxljq8ccx/edge_to_spline.jpg) (http://postimg.org/image/cxljq8ccx/)

http://www.digitalfossils.com/Download/NVil-May-18-16.rar

  * Edge mode > Geometry > Create Splines.

Title: Re: streamline edge(spline) to tube
Post by: IStonia on May 21, 2016, 07:57:25 am

http://www.digitalfossils.com/Download/NVil-May-18-16.rar

  * Edit > Customize > Tools > Object Shortcut Tools > Create Tube.
  * two new basic streamlinen tools. Generic Tools > Mixed Tools > Create Tube From Spline. Edge Tools > Mixed Tools > Create Tube From Edge.