NVil Forum

General Category => Bug Reports => Topic started by: steve on July 15, 2012, 11:37:18 pm

Title: Paint select
Post by: steve on July 15, 2012, 11:37:18 pm

Hello,

When using polygon paint select(X) the selection tool can take a while to exit.

Example:-

Create a 10 X 10 grid. In sub_object-polygon, press "X"(for paint select), left mouse(hold down) and paint select all the polygons on the grid. After releasing the mouse button, the select(circle) icon is active for about 5 seconds(selection tool does not exit), it then changes to the swirling cursor(program not responding) for a couple of seconds, then the tool exits.

Is it a problem on my setup, or with the tool?

Regards,

-Steve

Title: Re: Paint select
Post by: IStonia on July 16, 2012, 12:37:31 am

I have noticed that myself but haven't yet figured out the improvement solution. I use window's region operation and it seems the result of this operation causes overlaping regions and that increases the amount of computation a lot.

Title: Re: Paint select
Post by: steve on July 16, 2012, 02:21:25 am

OK, Thanks,

Regards,

-Steve