NVil Forum

General Category => Community Help => Topic started by: Stratos on July 09, 2012, 09:11:11 am

Title: Extrude with caps
Post by: Stratos on July 09, 2012, 09:11:11 am

There is a way to make an extrusion and create caps?

(http://i.imgur.com/9EUDX.jpg)

For now, I've bridged them, and cut where necessary to connect the pieces, but an automatic cap will be better :D

Title: Re: Extrude with caps
Post by: steve on July 09, 2012, 09:26:29 am

Hello,

If you are doing what I think (adding thickness), then try the "shell" command.
Go into "Mesh" selection(top right in visual tools), select the mesh, select "shell", then either add a thickness in the popup options, or left click and drag in the main view_port.

Title: Re: Extrude with caps
Post by: Stratos on July 09, 2012, 10:36:22 am

Quote from: steve on July 09, 2012, 09:26:29 am

Hello,

If you are doing what I think (adding thickness), then try the "shell" command.
Go into "Mesh" selection(top right in visual tools), select the mesh, select "shell", then either add a thickness in the popup options, or left click and drag in the main view_port.

Thanks a lot

(http://i.imgur.com/lJDHm.jpg)