NVil Forum

General Category => Community Help => Topic started by: steve on July 04, 2012, 01:46:45 pm

Title: evenly space vertex?
Post by: steve on July 04, 2012, 01:46:45 pm

Hello,

I was looking for an option to evenly space vertex along an open/closed edge loop. Is there such an option?

Thanks,

- Steve

Title: Re: evenly space vertex?
Post by: IStonia on July 04, 2012, 02:22:30 pm

Geometry > Common Commands n Tools > Space Loop/Curve Loop.

Title: Re: evenly space vertex?
Post by: steve on July 04, 2012, 02:30:43 pm

Excellent, thank you.

Title: Re: evenly space vertex?
Post by: steve on July 08, 2012, 03:28:22 pm

Hello again,

It appears that the space_loop only works on open(or broken) edge loops. If the edge loop is continuous/closed then the space_loop simply exits. If only a section of a continuous/closed edge loops is selected, again the tool simply exits.


Regards,

-Steve