NVil Forum

General Category => Community Help => Topic started by: crestburg on May 03, 2014, 05:17:35 pm

Title: How to select circle to extrude?
Post by: crestburg on May 03, 2014, 05:17:35 pm

Hi,
  I am new at this so bear with me please.  ;) I make a cylinder in silo, and drag the top lines and SHIFT X to cut. Then that leaves a smaller circle in the top of the cylinder where I can select those and press the Z key and a little ball appears that I can move the selected area in or out. I turned of the quad selection and made a cylinder with NVIL but can't seem to figure out how to do the same. Could someone please explain how that is done with NVIL?  :D
Thanks,
crestburg

Title: Re: How to select circle to extrude?
Post by: Darcvizer on May 03, 2014, 06:37:41 pm

please in pictures I do ,not understand English

Title: Re: How to select circle to extrude?
Post by: crestburg on May 03, 2014, 07:06:14 pm

There you go. Thanks for looking.
crestburg

Title: Re: How to select circle to extrude?
Post by: Darcvizer on May 03, 2014, 08:01:22 pm

describe as easy as possible, I can not understand that it is necessary

Title: Re: How to select circle to extrude?
Post by: Darcvizer on May 03, 2014, 08:08:03 pm

something like this?

https://www.youtube.com/watch?v=tRMoM0flmSw&feature=youtu.be

Title: Re: How to select circle to extrude?
Post by: crestburg on May 03, 2014, 08:14:08 pm

Quote from: Darcvizer on May 03, 2014, 08:08:03 pm

something like this?

https://www.youtube.com/watch?v=tRMoM0flmSw&feature=youtu.be

YES. That is exactly what I wanted to know. Thank you.  :)
crestburg