NVil Forum

General Category => Bug Reports => Topic started by: steve on June 11, 2012, 12:08:12 am

Title: Inset (build 07-june)
Post by: steve on June 11, 2012, 12:08:12 am

Hello,

Not sure if a possible bug, or intentional?.
When making an inset in this latest version, it is sometimes the surrounding geometry moving rather than the inset, although I cannot find any consistency, as sometimes it does work as in previous versions.
So as example. If you have a cube, select a face, run inset, the sides of the cube move rather than the inset.


Regards,

- Steve

Title: Re: Inset (build 07-june)
Post by: IStonia on June 11, 2012, 02:22:05 am

It is not a bug. The app decide the inset/outset style base on the initial cursor drag direction. This is to slim down the ui. Please see the discussion here
http://www.polycount.com/forum/showthread.php?t=74005&page=73

You are wellcome to join the discussion of the outset style raised by MightyPea.

Title: Re: Inset (build 07-june)
Post by: steve on June 11, 2012, 11:38:22 pm

My error then.

Regards,

- Steve

Title: Re: Inset (build 07-june)
Post by: steve on June 20, 2012, 01:39:00 pm

I see you have now added (june-20 build) a "Follow outside shape", which gives a result I was looking for.

Many thanks.

Regards,

- Steve