NVil Forum

General Category => NVILL Discussion => Topic started by: steve on March 30, 2014, 06:56:30 pm

Title: Scaling
Post by: steve on March 30, 2014, 06:56:30 pm

Hi IStonia

With moving and rotating, the cursor, although it stops at edge of view_port, the move/rotate will still continue. But with scaling, that is limited, and stops at view_port edge with cursor.

I am wondering if that is a limitation, or just not implemented?

Thanks,

NOTE.
Just noticed, it is only limited by view_port edge when stepping is disabled.

-------------------------------------------------
I have also just noticed that when in orthographic views, object translation will stop at view_port edge (although the "Transform Value display" will continue to change). But again, that is with stepping disabled.