NVil Forum

General Category => NVILL Discussion => Topic started by: subdproxy on September 20, 2011, 12:22:05 am

Title: Bench
Post by: subdproxy on September 20, 2011, 12:22:05 am

Haven't really tried it until today. Finally had a better chance to look at this than before. Easy to learn and the workflow is nice. Made this from the time I opened up Void World until Render. 20 minutes to Model in Void WOrld and 10 minutes to texture and Render. Good Job on the program! I am going to try and complete a Pagani (a very expensive car) now. Hopefully I can be done with that soon.

The only issue I had was selecting Vertices in Wireframe mode. I can never figure out how to select Vertices on the other side of the object. I always had to rotate the object and select them.

Glen

http://debellostudios.com/2011/09/19/void-world-3d-program/ (http://debellostudios.com/2011/09/19/void-world-3d-program/)

Title: Re: Bench
Post by: Passerby on September 20, 2011, 12:36:50 am

use mmb drag to select occluded verts and edges.

Title: Re: Bench
Post by: subdproxy on September 20, 2011, 03:21:00 am

Well check that out, all it was is a MMB. Thanks!

Glen