NVil Forum

General Category => Bug Reports => Topic started by: Vaquero on June 10, 2013, 07:21:15 pm

Title: Edge_DoubleLoop_Slide_Adj/OffCenter
Post by: Vaquero on June 10, 2013, 07:21:15 pm

I just tried the Edge_DoubleLoop_Slide_Adj/OffCenter streamline basic tools and have some issues.
Because the tools are named "slide" I expected a slide that doesn't leave the limits of the surface. Just take a look at the comparison below to see what I mean:
(http://i.imagebanana.com/img/a420ybmy/thumb/NVil_DoubleSlideOffcenter1.jpg) (http://www.imagebanana.com/view/a420ybmy/NVil_DoubleSlideOffcenter1.jpg)
Is this intentional?

And also: It would be better to put the alteration between even/proportional onto a hotkey other than ctrl/shift, for example caps lock or space, because ctrl/shift also controls steppings and I am not able to do proportional with steppings at the same time with these current settings.

Title: Re: Edge_DoubleLoop_Slide_Adj/OffCenter
Post by: IStonia on June 17, 2013, 10:10:42 am

The new feature is added.