NVil Forum

General Category => Bug Reports => Topic started by: mightypea on May 27, 2013, 07:45:21 pm

Title: ' Spherize' moves things to the symmetry line
Post by: mightypea on May 27, 2013, 07:45:21 pm

The Spherize tool is moving things to the symmetry center. This is only true for the Spherize tool, not the streamline version (circularise). On another note: Could we get a visual tool version of the Circularise command, so I can add it to my radial menu? I really much prefer the results.

Title: Re: ' Spherize' moves things to the symmetry line
Post by: Passerby on May 27, 2013, 09:50:46 pm

ya has happed to me, what do is turn symmetry off do the spherize, select the geo, than do a re-symmetry, than enable symmetry

Title: Re: ' Spherize' moves things to the symmetry line
Post by: mightypea on May 27, 2013, 10:03:10 pm

The same thing seems to happen with curve loop.

This has never happened to me before, and I use symmetry all the time. I suppose I just lucked out :D

Kun, can you look into this? I could send you a mesh, but it happens on every file. I just make a cube, subdivide it and symmetry cut it.

Title: Re: ' Spherize' moves things to the symmetry line
Post by: IStonia on May 28, 2013, 08:41:10 am

Fixed. I don't see the problem with Curve Loop.