NVil Forum
General Category => Bug Reports => Topic started by: steve on April 10, 2013, 06:30:09 pm
-
Hello,
Not a bug, just a (possibly) missing option?.
In Spline_Vertex Lathe, on the "Move per Turn", there is no up/down to change the integer value.
-
It is not an integer value. It is a floating point value. You need to set the number turns value to 2 and over, then set the 'Move per Turn' to a non-zero value before you can drag to change it's value.
-
It is not an integer value. It is a floating point value.
I was just looking for a way to quickly change the value in steps of 1, without having to manually enter a Integer(a number without decimal component).
You need to set the number turns value to 2 and over, then set the 'Move per Turn' to a non-zero value before you can drag to change it's value.
That is only a limitation on the dragging, I can enter what ever value I want into the "Move per Turn" without having to change the "Number Turns". If that is a bug, do not fix it, because in fact, there are many times I do not want more than 1 turn, but do want a move on that single turn.
I also think the limitation of only being able to have full turns is quite limiting. Normally with "Lathe" I can enter a deg of rotation or a decimal value.
-
... You need to set the number turns value to 2 and over, then set the 'Move per Turn' to a non-zero value before you can drag to change it's value.
Actually I got it wrong. The 'Move per Turn' does work on one single turn.
I will try to solve the full turn limitation.
-
I will try to solve the full turn limitation.
No rush, have a look when you have time.
Thanks,
-
Fixed.
-
Many Thanks,
I will try it later, currently putting together a new box(Computer).