NVil Forum
General Category => Community Help => Topic started by: steve on July 04, 2012, 01:46:45 pm
-
Hello,
I was looking for an option to evenly space vertex along an open/closed edge loop. Is there such an option?
Thanks,
- Steve
-
Geometry > Common Commands n Tools > Space Loop/Curve Loop.
-
Excellent, thank you.
-
Hello again,
It appears that the space_loop only works on open(or broken) edge loops. If the edge loop is continuous/closed then the space_loop simply exits. If only a section of a continuous/closed edge loops is selected, again the tool simply exits.
Regards,
-Steve