NVil Forum
General Category => Bug Reports => Topic started by: xenoox on May 16, 2018, 05:29:30 pm
-
Whenever I try vertex extrusion on vertex that has more then 7 edges connected I get crash.
(http://i65.tinypic.com/2zhh4xx.jpg)
-
Do you mean the vertex extrusion function in Retopo tool? I couldn't reproduce it. Can you show in a video and any error messages you received?
-
Yes, retopo tool extrusion. No massage whatsoever, just regular freeze and crash (click on image to view gif)
(https://preview.ibb.co/cx3tQd/Vertex_extrusion.gif) (https://ibb.co/hM7L5d)
It crashed on my multiple times, and I lost few hours of work before I figured out what was the cause. I presume it was requested before, but is there any chance for autosave function in the near furure?
-
I will think about the auto save feature. It is not a good practice not saving the scene for hours.
I just can't reproduce it. Is it the Shift+Drag action on an vertex? Does it happen every time?
Can you send me your config files?
-
Agree about saving, Im trying to save often, but sometimes I tend to forget when I'm in the zone, doing something. Another thing is if you're loosing 5-20 minutes of work with each crash, and it crashes on you few times a day, it can add pretty quickly.
I attached my zipped config files.
I checked this bug on two PC's, 100% repo rate on my end.
-
Try this
http://www.digitalfossils.com/Download/NVil-May-18-18.rar
Can you make a thread in Feature Request section for auto-save?
-
Fixed. Thanks!
Ok. I will start new thread.