NVil Forum
General Category => Bug Reports => Topic started by: kevjon on August 05, 2018, 02:09:23 am
-
I'm having a issue with this tool
I click where I want the cut to be made. That part is all fine.
If I continue to hold the LMB down and slide it too close to another edge it merges with the edge (either partly or entirely) and does not unstick. I always have to undo and try again.
-
Hi Kevyon,
The only thing I can currently think of, is that you may of set "Modeling Options > Auto Weld Enabled".
-
Steve
Thanks for that, it took a bit of searching through the menus to find it but yep you were right, turning off autoweld solved it.
Back in business now !