NVil Forum
General Category => NVILL Discussion => Topic started by: samardac on February 09, 2014, 07:45:36 pm
-
Is it any tool analog of 3Ds Max/Wings 3D - Flow connect?
This command insert edge loop but keep curvature.
Check this video: http://www.youtube.com/watch?v=PXbxIL5yWSo (0:16)
-
Hello.
There's already a StreamLine tool for this:
Edge Tools >> Edge_Loop_Cut/Slide_MaintainCurvature#
-
Yes, You will need to setup a streamline tool.
Basic streamline tool > Edge tools > Edge_loop_Cut/Slide_MaintainCurvature.
There is some info in the help file for creating streamline tools, but just ask if you are not sure how to do that.
-
Thanx, looks like there are hidden comands :)