NVil Forum
General Category => Community Help => Topic started by: Tiles on August 31, 2012, 05:57:29 pm
-
When i select faces with the rectangle just the front faces gets selected. I am sure there is an option somewhere where you can select through, means select the backfaces too. But i cannot find it. Could somebody please enlighten me where this option is? :)
-
Hi Tiles,
Use the MMB for the rectangle selection.
-
I cannot. MMB is my rotate :(
Seems that i have to change the hotkey then. How is this option called?
-
Hi Tiles,
Shortcut key:- EDIT-> Customize-> Tools: Common Modeling Shortcut Tools-> "Reverse Marquee selection facing intention"
Set that up with a shortcut key. When short_cut_key pressed(held down), the LMB rectangle selection will also select back facing.
-
Thanks Steve. Doesn`t work, unfortunately. What happens is that all edges gets selected in face selection mode in the moment the rectangle touches the mesh.
EDIT, argh, i was in the wrong mode. Works like charm. Many thanks :)
-
Hi Tiles,
You edited as I was replying. Good to see you sorted it.
Regards,
-Steve
-
See above, i was in the wrong mode. And was too slow with editing my post then. All is well. Thanks again :)