NVil Forum

General Category => Feature Requests => Topic started by: samardac on December 12, 2015, 09:59:05 am

Title: Template file.
Post by: samardac on December 12, 2015, 09:59:05 am

Hay IStonia,
Can you add support for Template file?
It will solve som many, many problems.
I have about 3-4 requests that I did not post yet and all that request will be solved with this one feature!

If template file is set, Nvil will just load this .vws at startup.

For example in MoI it looks like this:
(https://monosnap.com/file/Oxq0qbLuqHV92W9zA0DHK33oDJjDli.png)

Title: Re: Template file.
Post by: samardac on December 12, 2015, 11:04:54 am

Forget to say, when new project will be started with template and user run save command template will not be overwrited insteat, nvil will open save dialog like there was no any template file loaded. And path in this dialog will be not from template but as always, like there is no any template.

Title: Re: Template file.
Post by: IStonia on December 15, 2015, 09:07:35 am

Is that file specific to MoI? What does it do?

Title: Re: Template file.
Post by: samardac on December 15, 2015, 09:34:41 am

It is just simple project file like .vws in NVil.
That template file works like if you load .vws when you start new project. And that .vws consists some defaults like turned off symmetry, vieport layout, subd level etc... It even can contain some predefined geometry. A lot of different defaults that you can save in .vws.

Title: Re: Template file.
Post by: mkdm on September 21, 2016, 03:08:55 pm

Hi Istonia,

....what about the "Template File" requested feature ?

It is lost ? :)

It would be very, very useful...

I hope you would add it in the next update.

Nice day,

- Marco (mkdm)