NVil Forum
General Category => Bug Reports => Topic started by: TinyTracker on June 17, 2022, 05:31:52 pm
-
Click cylinder.
Draw 1 stroke with cylinder tool activated.
Now while drawing the second stroke for the depth of cylinder. Click middle mouse button to toggle the radio buttons for X, Y, Z. The cylinder will change direction.
Move the mouse around while adjusting the depth and the cylinder orientation will reset.
-
I could not reproduce the problem you're describing. When I move my mouse to set depth after changing orientation, the orientation does not reset. It only changes direction to a negative of a selected orientation if I move past the origin of the orientation axis.
The only problem I noticed is that setting depth is a little choppy, but it might be because I'm running NVil on GNU/Linux.
Tested on NVil 2022-Jun-26, so perhaps it was already fixed(?).
-
Tested on NVil 2022-Jun-26
Where did you get that build from. I do not see a link on the forum.
-
It might be one of test versions IStonia sent me after a bug report or feature request.