NVil Forum
General Category => Community Help => Topic started by: Stratos on July 09, 2012, 09:11:11 am
-
There is a way to make an extrusion and create caps?
(http://i.imgur.com/9EUDX.jpg)
For now, I've bridged them, and cut where necessary to connect the pieces, but an automatic cap will be better :D
-
Hello,
If you are doing what I think (adding thickness), then try the "shell" command.
Go into "Mesh" selection(top right in visual tools), select the mesh, select "shell", then either add a thickness in the popup options, or left click and drag in the main view_port.
-
Hello,
If you are doing what I think (adding thickness), then try the "shell" command.
Go into "Mesh" selection(top right in visual tools), select the mesh, select "shell", then either add a thickness in the popup options, or left click and drag in the main view_port.
Thanks a lot
(http://i.imgur.com/lJDHm.jpg)