NVil Forum

General Category => NVILL Discussion => Topic started by: steve on September 22, 2012, 09:57:51 am

Title: Spline modify problem
Post by: steve on September 22, 2012, 09:57:51 am

Hello,

When using the "Spline Modify", I select the vertex on the mesh to modify, press(hold down) "A" for axis, click on the spline, but the vertex are then deselected. The same when selecting the Path(P+LMB) or other modify function curves.
I did not have this problem when using this method in earlier builds of Nvil. Could someone verify this please?

[ to add: If I press (for example) "P"+RMB on the path first, then "P"+LMB on the path, the vertex remain selected.]


Thanks,

-Steve

Title: Re: Spline modify problem
Post by: IStonia on September 22, 2012, 11:00:31 am

It is a bug.

Title: Re: Spline modify problem
Post by: steve on October 13, 2012, 08:28:52 pm

While in the "Spline modify" function, the "S" key no longer allows the selecting of the "Scale modifier", but instead brings up the streamline tool "Weld Vertex"

-----------
Fixed  :)